CONFIDENTIAL
Paper roll Mechanism control commands GS V
Ver. 10.05 p. 374
■ When using these commands, there is a gap between the cutting position and the print position.
[Note for <A>]
■ If an autocutter is provided, this command can be used.
[Notes for <B>]
■ When n = 0, the printer feeds the paper to the cutting position and cuts it.
■ If an autocutter is not provided, the printer only feeds the paper for specified amount.
■ Vertical motion unit is used for calculating a paper feed amount.
[Notes for <C>]
■ Vertical motion unit is used for calculating a paper feed amount.
■ Basic paper feed amount differs, depending on the models.
■ Paper is fed for the same amount as a cutting range when processing this function.
■ The paper will not be cut when this command is executed. When a cutting position reaches an autocutter
position after printing and feeding the next receipt, the printer executes a cutting.
■ When a cutting range specified is larger than a top margin (physical distance between the autocutter and
print head), the cutting range is forced to be the amount of the top margin.
■ It is possible to set multiple cutting ranges.
■ Even if the cutting is set to be large, only one cutting will be executed for each cutting range.
■ The cutting range specified is effective until a paper cut is executed, ESC @ is executed, the printer is reset,
or the power is turned off.
■ If an autocutter is provided, this command can be used.
■ The function makes it possible to save paper by reducing the top margin for continuous printing.
[Notes for <D>]
■ If an autocutter is provided, this command can be used.
■ When n = 0, the printer feeds the paper to the cutting position and cuts it.
■ Vertical motion unit is used for calculating a paper feed amount.
■ The function makes it possible to save paper by reducing the top margin for continuous printing.
Kommentare zu diesen Handbüchern