CONFIDENTIAL
Paper roll Miscellaneous commands GS P
Ver. 10.05 p. 484
GS P
SETTING COMMAND
[Name] Set horizontal and vertical motion units
[Format] ASCII GS P x y
Hex 1D 50 x y
Decimal 29 80 x y
[Range] 0 ≤ x ≤ 255
0 ≤ y ≤ 255
[Default] TM-J2000/J2100, TM-T88IV: x = 180, y = 360
TM-T90: x = 180, y = 360 [Other than Japanese model]
x = 203, y = 406 [Japanese model]
TM-T70: x = 180, y = 180 [Other than Japanese model]
x = 203, y = 203 [Japanese model]
TM-L90: x = 203, y = 406
[Printers not featuring this command] TM-P60, TM-U230, TM-U220
[Description] Sets the horizontal and vertical motion units to approximately 25.4/x mm {1/x"} and approximately 25.4/y
mm {1/y"}, respectively.
• When x = 0, the default value of the horizontal motion unit is used.
• When y = 0, the default value of the vertical motion unit is used.
[Notes]
■ The horizontal direction is perpendicular to the paper feed direction and the vertical direction is the paper
feed direction.
■ The horizontal and vertical motion units indicate the minimum pitch used for calculating the values of
related commands (shown on the next screen).
■ In standard mode, the following commands use x or y.
• Commands using x: ESC SP, ESC $, ESC \, GS ( P, GS L, and GS W
• Commands using y: ESC 3, ESC J, ESC K, GS ( P and GS V
■ In page mode, the following commands use x or y, when the starting position is set to the upper left or
lower right of the print area using ESC T.
Kommentare zu diesen Handbüchern