Epson TM-J2000 Spezifikationen Seite 298

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 761
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 297
CONFIDENTIAL
Paper roll Status commands DLE EOT
Ver. 10.05 p. 298
When an ink near-end is detected, the INK OUT light blinks. It is possible to print approximately
20,000 characters using Font B with print control mode = economy printing specified from the
time an ink near-end is detected until an ink end is detected. However, the value is only a
reference value, it depends on environmental factors such as printing data, and the timing of
head cleaning. Therefore, replace an old ink cartridge with a new one when a ink near-end is
detected.
TM-J2000 (single-color) does not support ink status B (n = 7, a = 2).
Two ink cartridges combined are installed in the TM-J2100 (two-color), and the presence of the
cartridge is detected with one detector. Therefore, both of the following status items are the
same.
Bit 5 of Ink Status A
Bit 5 of Ink Status B
TM-T90
BUSY condition for a parallel interface is selected by memory switch 1-3.
Roll paper sensor status (n = 4)
When the cover is open, the status of the roll paper end sensor (bit 5, 6) retain the value when the
cover was closed immediately before.
TM-L90
TM-L90 with Peeler
BUSY condition for a parallel interface is selected by memory switch 1-3.
The peeling issuing mode or the continuous issuing mode (not using peeler) can be selected by a
switch on the printer. This is a slide switch that can be used when the roll paper cover is open.
Printer cause status (n = 1)
Online recovery wait (bit 5) is changed when GS ^ is executed or the printer is in one of the
following status conditions when the peeling issuing mode is selected.
Waiting for the FEED button to be pressed with the cover closed.
Seitenansicht 297
1 2 ... 293 294 295 296 297 298 299 300 301 302 303 ... 760 761

Kommentare zu diesen Handbüchern

Keine Kommentare