Epson F2000 Bedienungsanleitung PDF herunterladen (Seite 52)

Tips for Administrator 52

Configuration Workflow

IPsec requires a client with secure access to the product and configured according to your

purposes. Access Control requires that the product be configured according to your

purposes.

The configuration workflow is shown below.

Note:

If your network is already secure, we recommend that you connect the product to a computer on a

different network before adjusting settings. There is potential for data theft if the product is

connected to a secure network when settings are adjusted. If no other network is available, refer to

the “Encrypting communications”, below.

1. Connect the product and the computer that will be used to configure the product to the

network.

2. Adjust Remote Manager settings.

See the following page information on Remote Manager settings.

3. Transmit the settings to the printer.

4. Adjust client computer security settings (not required for Access Control).

5. Connect the printer to a secure network.

Important:

The network connection will close if Network Setup > IPsec Setting is enabled in the product

control panel and a blank key is entered for PSK Setting (i.e. no pre-shared key is entered). Be

sure to enter a key for PSK Setting after enabling Network Setup > IPsec Setting in the product

control panel.

Encrypting communications: There is potential for data theft if product settings are adjusted

over a secure network. If no other network is available, follow the steps below to encrypt the

data for transmission.

(1) In the product control panel, select Network Setup > IPsec Setting > Enable and enter the

pre-shared key.

(2) Set up IPsec on the computer that will be used to configure the product.

(3) Connect the product and the computer that will be used to configure the product to the

network.

1 2 ... 47 48 49 50 51 52 53 54 55 56

Keine Kommentare

Epson F2000 Bedienungsanleitung Seite 52