Epson EMP-X3 Bedienungsanleitung PDF herunterladen (Seite 76)

List of ESC/VP21 Commands

USB Connection Setup

In order to control the projector using ESC/VP21 commands via a USB

connection, the following preparations must be carried out.

PROCEDURE

Download the USB driver (USB-COM Driver) from the

EPSON website to your computer.

The URL is as follows.

http://esupport.epson-europe.com/downloads/en/

Install the downloaded USB driver onto your

computer.

Read the instructions displayed on the download screen.

Set "Link21L" to "On" in the "Extended" menu.

Select "USB" for "COM port" in the "Extended" menu.

Turn the projector's power off.

Turn off this projector after the confirmation buzzer

beeps twice.

Once the projector's power has turned back on, communication

via a USB Connection will then be possible.

Serial connection (EMP-82/62 only)

• Connector shape : D-Sub 9 pin (male)

• Projector input connector : Control (RS-232C)

<At projector> (PC serial cable) <At computer>

Signal Function

GND 5 5 GND

GND Signal wire ground

RD 2 3 TD

TD Transmit data

TD 3 2 RD

RD Receive data

DTR 4 6 DSR

DSR Data set ready

DSR 6 4 DTR

DTR Data terminal ready

If you disconnect the power cable before the

confirmation buzzer beeps twice, the communication

port is not changed.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 84 85

Keine Kommentare

Epson EMP-X3 Bedienungsanleitung Seite 76