Epson EMP-X3 Bedienungsanleitung PDF herunterladen (Seite 62)

Maintenance

This section describes maintenance tasks such as cleaning the projector and

replacing consumable parts.

Cleaning

You should clean the projector if it becomes dirty or if the quality of

projected images starts to deteriorate.

Clean the projector's surface by wiping it gently with a soft cloth.

If the projector is particularly dirty, moisten the cloth with water

containing a small amount of neutral detergent, and then firmly wring the

cloth dry before using it to wipe the projector's surface. Then wipe it again

with a soft, dry cloth.

Use a commercially-available air blower, or use a lens cleaning paper to

gently wipe the lens.

If dust collects on the air filter or the air outlet, it can cause the internal

temperature of the projector to rise, and this can lead to problems with

operation and shortening of the optical engine's service life.

It is recommended that you clean these parts at least once every three

months. Clean them more often than this if using the projector in

particularly dusty environments.

Make sure you read the separate Safety Instructions/

World-Wide Warranty Terms before cleaning.

Cleaning the Projector's Surface

Do not use volatile substances such as wax, alcohol or

thinner to clean the projector's surface. These can

cause the projector to warp and make the coating finish

peel off.

Cleaning the Lens

Do not rub the lens with harsh materials or subject the

lens to shocks, as it can easily become damaged.

Cleaning the Air Filters and Air Intake Vent

If the air filters are broken or if the warning message

reappears after they have been cleaned, they should be

replaced. Replace with a new air filter. See "Replacing

the Air Filter". sp.63

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 84 85

Keine Kommentare

Epson EMP-X3 Bedienungsanleitung Seite 62