Epson CW3S20A Bedienungsanleitung PDF herunterladen (Seite 117)

If your hard disk needs to be formatted, begin by selecting the

Command Prompt option from the DOS shell. Enter the

following command:

The floppy disk drive indicator will come on for a few seconds,

while the FORMAT command is loaded into memory. When

the light goes out, the computer will display:

You should already have made sure that there is no information

stored on the hard disk that you want to save. Press Y to begin

formatting. The formatting process takes several minutes.

When it is completed, the system will display:

Here, your computer is asking you to name your hard disk

drive. This is a result of the /V switch used with the FORMAT

command. A disk label can be useful when sorting directories,

so you may want to enter one now.

A volume label can use up to eleven characters. See Chapter

4, “Using MS-DOS,” for a list of valid label characters. When

you have entered the drive label, your computer will respond:

Using

Your Hard Disk

6-9

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 165 166

Keine Kommentare

Epson CW3S20A Bedienungsanleitung Seite 117