Epson Equity III+ Bedienungsanleitung PDF herunterladen (Seite 21)

Connect the other end of the cable to the printer as shown in Figure

1-11. To secure the cable, tighten the squeeze locks at each side of the

printer port and push them into the connectors on each side of the

cable.

Figure 1-11. Connecting the printer

Plug the printer’s power cable into an electrical outlet.

Serial interface

If you have a printer (or another peripheral such as a modem) with a

serial interface, connect it to the serial (RS-232C) port at the back of the

main unit. The Equity III+ uses a DB-9P connector, so be sure you have a

compatible cable (or an adapting cable that converts the 9-pin output to the

standard 25pin output). To connect a serial device, follow the same steps

above for connecting a parallel device.

You need to ensure the serial port is set up so it functions properly. If you

are using the port for a serial printer, you must also redirect printer output to

the serial instead of the parallel port. Use the MS-DOS SETMODE program

(or the MODE command) to make these changes. See your MS-DOS man-

ual for instructions.

The Equity III+ character set

The Equity III+ uses a special character set that assigns graphics and

international characters to some of the ASCII codes. In most cases, if you try

to print these characters on a standard printer, you get italic characters

1-12

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 79 80

Keine Kommentare

Epson Equity III+ Bedienungsanleitung Seite 21