Epson Equity III+ Bedienungsanleitung PDF herunterladen (Seite 20)

Connecting a Printer

The Equity III+ has both parallel and serial interfaces. You can easily

connect a printer or plotter that has either type of interface-just follow the

instructions below. Epson offers a full range of printer products. Consult

your dealer for more information.

Parallel interface

The Equity III+ parallel interface is Centronics®-compatible and uses a

DB-25S connector. Most Epson printers have parallel interfaces.

To connect a printer to the main unit, you need an IBM-compatible

printer cable. If you are not sure which one you need, consult your Epson

dealer. Once you have a printer cable, follow these steps to connect your

printer to the parallel interface on the main unit:

Place the printer next to your system.

Before you connect the printer, be sure the power switches on both the

main unit and the monitor are off.

One end of the printer cable has a 25-pin male D-connector. (Refer to

your printer manual to determine which end this is.) Connect this end

to the parallel port on the back panel of the main unit, as shown in

Figure 1-10. If the plug has retaining screws, tighten them with a small

screwdriver.

Figure 1-10. Connecting the printer cable to the parallel port

1-11

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 79 80

Keine Kommentare

Epson Equity III+ Bedienungsanleitung Seite 20