Epson NX Wartungshandbuch PDF herunterladen (Seite 64)

Removing

and

Replacing Subassemblies

Installing Another Processor

You can install a future Intel OverDrive processor in the Epson NX system, when it becomes

available.

Caution

You must observe strict anti-static procedures to avoid

damaging the CPU as you install or remove it.

Follow these steps to install the CPU in socket U5:

Remove the cover (see page 3-2) and any option card that may be in the way of

accessing the socket (see page 3-5). Remove any attached heat sink.

Raise the lever up and over the ZIF socket (see Figure 3-8). This will release the

pressure holding the legs of the CPU in the socket.

Gently lift the CPU out of the socket and place it in an anti-static bag for protection.

Figure 3-8 Removing/Installing the Processor

Locate the orientation dot in one corner of the new CPU and turn the CPU so that the

dot is in the position shown in Figure 3-8. Be sure the dot is aligned with the corner

that has a ” 1” printed on the system board.

Caution

you insert the CPU in the wrong position, you could

permanently damage it.

Gently lower the CPU into the ZIF socket and raise the lever up over the socket so

that it locks in place. Examine the CPU to be sure it is inserted all the way into the

socket and is secure.

Attach a heat sink to the top of the CPU.

Replace any option card removed and the cover.

Epson

Service

Manual

3-11

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 153 154

Keine Kommentare

Epson NX Wartungshandbuch Seite 64