Epson EMP 600 Bedienungshandbuch PDF herunterladen (Seite 38)

20 2 • Using the Projector

Turning the Equipment On and Off

Always turn on the projector and its attached equipment in the

following order.

1. Video source

2. Audio source (if different than computer or video source)

3. Projector

4. External speaker or PA system

5. Computer

Remove the projector’s lens cap before turning on projector. The

operation indicator will flash for a while and then light up to indicate

that power is on. If a computer or video equipment is attached to the

projector, the video signal or computer signal from the attached

equipment will be projected. It will take at least 30 seconds after

turning the power on before a normal image appears.

◆

Warning:

Never look into the lens when the lamp is on. This can

damage your eyes. It is especially important that children are not

allowed to look into the lens.

◆

Note:

Remove the projector’s lens cap when you project. The light

from the projector may cause the lens cap to warp.

Reverse the order shown above to turn off the projector and other

equipment. After you press the Power button to turn off the projec-

tor, the fan will remain on and the operation indicator will flash

orange for about one minute as the projector cools. The indicator

stops blinking (and remains lit in orange) when the cooling operation

is complete.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 121 122

Keine Kommentare

Epson EMP 600 Bedienungshandbuch Seite 38