Epson EMP 600 Bedienungshandbuch PDF herunterladen (Seite 18)

xiv

Introduction

Remote control information

The EMP-7100/5100 can be operated by remote control via infrared

(IR) receivers located at the front of the projector. The projector may

not respond to remote control commands under the following

conditions:

• The ambient light is too bright.

• Certain types of fluorescent lighting are used.

• A strong light source shines into the IR receiver.

• Other equipment that emits infrared energy, such as a radiant

room heater, is in the room.

These conditions commonly cause problems for most infrared-

controlled equipment.

Try the following solutions:

• The remote control unit’s batteries may be low on power, replace

them.

• Dim the ambient lighting and/or move the projector out of direct

sunlight.

• Close any window coverings and/or move the projector out of

direct sunlight.

• Switch off other equipment that emits infrared energy.

Remember, you can always control your computer-based presentation

directly from the computer, even in an environment containing one

of the conditions listed above.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 121 122

Keine Kommentare

Epson EMP 600 Bedienungshandbuch Seite 18