Epson PRO4000 Bedienungsanleitung PDF herunterladen (Seite 2)

STEP 2

If you are currently using original Epson Ultrachrome inks in the printer and are about to install Cave Paint

Elite inks, Cave Paint Photochrome V2 inks, or Media Street by Ink2image Generations G6X inks in the

refillable cartridges, then proceed to step 3. If you are currently using a different ink type, or intend to install a

different Ink2image ink than mentioned above, it is a good idea to flush out your printer before installing the

system. Otherwise, you will waste a lot of time and ink purging through one ink type to another, or potentially

clog your printer. Ink2image supplies Dead Head cleaning fluid in bulk for the purpose of flushing the printer

and this can be obtained from your local Ink2image supplier. If you are in doubt about the need to flush your

printer, then contact your local supplier or e-mail Ink2image at [email protected]om. Ink2image will not

be held responsible for problems caused by the incompatibility of different ink types.

If you do need to flush out your printer, then fill each refillable cartridge with about 1” of Dead Head cleaning

fluid and perform an initial fill routine as outlined in the ‘Installing all cartridges at once’ section below. Ideally

let the printer ‘soak’ overnight to allow the cleaning fluid to dissolve any dried ink deposits. Remove the

refillable cartridges and return any remaining cleaner in the cartridges to the cleaning fluid bottle by pouring

the fluid out through the cartridge filling hole. Fill the cartridges with the new ink, and perform another initial

fill routine to prime the ink system with ink.

STEP 3

Ink2image refillable cartridges for the Epson Pro 4000/7600/9600 are fitted with normal ink monitor chips

that will allow you to use the cartridges once before the printer will show an ‘empty cartridge’ warning. This

makes it possible to install the cartridges one at a time so that existing standard cartridges in the printer can

be used up. However, once the printer is installed with the complete set of refillable cartridges, the chip

reading function on the printer will need to be turned off so that the cartridge chips do not monitor ink levels.

This can be done by turning on the printer in ‘self testing’ mode and following the procedure below. This

process is reversible should you want to use normal cartridges again in the future. If you are going to install

the refillable cartridges one at a time then only turn off the chip readers once the printer has the complete set

of refillable cartridges installed.

It is recommended that this procedure only be used on machines running a full set of refillable cartridges. The

machine will no longer count ink usage, and will not show an ‘empty cartridge’ condition. The printer operator

is responsible for ensuring that refillable cartridges are not allowed to run empty. Please follow the

instructions carefully, as incorrect entries could result in problems that would require a service call to reload

the printer firmware.

Turning off the chip readers on an Epson 4000 Printer

Start with the printer turned off.

Press and hold the Left Arrow, Up Arrow, and Down Arrow buttons, and push the Power button to turn on

the printer.

When the display shows ‘SELF TESTING’, release all buttons.

Press Down Arrow once, until you see ‘SERVICE CONFIG’ on the display.

Press the MENU button once. The display will read ‘CHANGE DEVICE-ID’.

Press the Down Arrow button two times, until the display reads ‘ED MODE’.

Press the MENU button once.

The display reads ‘*X’.

1 2 3 4 5 6 7

Keine Kommentare

Epson PRO4000 Bedienungsanleitung Seite 2