Epson Endeavor Spezifikationen PDF herunterladen (Seite 10)

EPSON Endeavor P60

Error messages (continued)

ISA NM messages

ISA NMI message

Description

Memory Parity Eror at

Memory failed; if the memory location can be

determined, it is displayed as xxxxxx; if not, the

message is Memory Parity Error ????

I/O Card Parity Error at

An expansion card failed; if the address can be

determined, it is displayed as xxxxx: if not, the

DMA Bus Time-out

message is l/O card Parity Error ????

A device has driven the DMA bus signal for more

than 7.8 microseconds

EPSON Endeavor P60 - 10

3/94

Tested Operating Environments

Although the system will run most software applications,

the following operating environments have been tested for

compatibility with this system.

Microsoft MS-DOS

Novell DR DOS 6.0

Novell NetWare 2.2, 3.12, and 4.01

Novell NetWare Lite 1.1

IBM OS/22.1

SCO UNIX release 3.2, version 4.2

SCO Open Desktop 3.0

Microsoft Windows 3.0 and 3.1

Microsoft Windows for WorkGroups 3.11

Microsoft Windows NT 3.1

NextStep version 3.2

LAN Manager

This system has also received Novell’s ‘Yes, NetWare tested

and approved” certification as a workstation and file server.

As new environments become available, these also will be

tested and certified.

Installation/Support Tips

System Power Requirements

If the power cord supplied with the system is not compatible

with the electrical outlet, obtain a cord that meets these

criteria :

The cord must be rated for at least 125% of the current

rating of the AC voltage system.

The cord must be less than 4.5 meters (14.8 feet) long.

The connector that plugs into the electrical outlet must be

an appropriately designed male grounding-type

connector.

The connector that plugs into the computer must be an

IEC type CEE-22 female connector.

Do not use or attempt to modify the supplied AC power cord

if it is not the type required for use in your region.

To avoid permanent damage to the computer, be sure the

voltage selector switch is set to the correct input line voltage

before you turn on the power. Verify that the voltage selector

switch is set to the correct setting. The 115 VAC setting is

appropriate for line source voltages between 100 and 120

VAC. If the line source voltage in your location is between

200 and 240 VAC, make sure you set the switch to 230 VAC.

To avoid damage to the system board or power supply, do

not exceed a total of 145 Watts power draw.

1 2 ... 5 6 7 8 9 10 11

Kommentare zu diesen Handbüchern

Keine Kommentare

Epson Endeavor Spezifikationen Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für PC / Workstation Barebones Epson Endeavor