Epson PowerLite S3 Spezifikationen PDF herunterladen (Seite 13)

Epson PowerLite S3 Projector

3/05 Epson PowerLite S3 Projector - 13

3. Loosen the lamp cover screw with the screwdriver that is

supplied with the spare lamp (or your own cross head

[Phillips] screwdriver).

4. Then slide the lamp cover straight forward and lift it to

remove.

5. Loosen the two lamp screws with the screwdriver that is

supplied with the spare lamp (or your own cross head

[Phillips] screwdriver).

6. Take out the lamp. Hold the lamp as shown in the

illustration below and lift it up and out of the projector. If

the lamp is broken, replace it with a new lamp, or contact

Epson for further advice. If replacing the lamp yourself, be

careful to avoid pieces of broken glass.

7. Insert the new lamp so that it fits in place correctly. Once it

is fully inserted, tighten the two screws.

8. Slide the lamp cover onto the projector and tighten the cover

screw.

Note: Install the lamp securely. If the lamp cover is removed, the

lamp turns off automatically as a safety precaution. Moreover, the

lamp will not turn on if the lamp or the lamp cover is not installed

correctly. The lamp contains mercury. Dispose of used lamps

properly in accordance with your local regulations.

Resetting the Lamp Timer

The projector has a built-in counter which keeps track of the

lamp operating time. When the cumulative operating time

reaches a certain point, it causes the replacement warning

message to be displayed. Therefore, the counter needs to be

reset after the lamp has been replaced with a new one. You can

do this using the configuration menu.

Note: Do not reset the lamp operating time except after the lamp

has been replaced, otherwise the lamp replacement period will not

be indicated correctly.

1. Connect the power cable and turn on the projector.

1 2 ... 8 9 10 11 12 13 14

Keine Kommentare

Epson PowerLite S3 Spezifikationen Seite 13