Epson Stylus Color IIs Betriebsanweisung PDF herunterladen (Seite 49)

Load/Eject Loads or ejects a sheet of paper. The printer

normally loads and ejects paper automatically.

Pause Stops printing temporarily. Press it again to resume

printing. To reset the printer, hold down this button

for about five seconds until all the lights turn on.

This clears the printer’s buffer and restores the

factory default settings.

Button combinations and power-on functions

The button combinations below let you perform additional

functions to control your printer.

Alt +

POWER

switch

Prints a demonstration page of the printer’s fonts

and colors. (Paper must be loaded in the printer.)

Hold down Alt until the printer feeds a page. To exit

demonstration mode, wait until the Pause light

comes on; then turn off the printer.

Load/Eject +

POWER

switch

Checks the paper length and performs a printer self

test at 360 dpi. Hold down Load/Eject until the

printer feeds a page. To stop the self test, press the

Pause button and then turn off the printer. See

“Testing the Printer” in the Setup Guide for more

information.

Alt + Pause Starts the print head cleaning cycle; see “Cleaning

the Print Head” in Chapter 3.

Pause +

POWER

switch

Enters the printer’s Default setting mode and prints

an instruction page; see “Using the Default Setting

Mode” on page 2-23 for more information. Hold

down Pause until the printer feeds a page. To exit

the Default setting mode, press the Pause button

and turn off the printer.

Hudson User’s Guide

A5 size Chapter 2

10-28-95 DR, pass 2-Rev1

Controlling the Printer 2-21

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 113 114

Keine Kommentare

Epson Stylus Color IIs Betriebsanweisung Seite 49