EPSON Stylus COLOR 1160
9/99 EPSON Stylus COLOR 1160
- 5
Installing an Ink Cartridge for the First
Time
Follow these ink cartridge precautions:
❏ Install both ink cartridges, and leave them installed for
all types of printing, or the printer won’t work.
❏ Remove the yellow tape seal from the top of the ink
cartridges or you’ll permanently damage them. Don’t
remove the clear seals on the bottom or ink will leak
out.
❏ Don’t open an ink cartridge clamp to remove a
cartridge except to replace it with a new one. Once
you remove a cartridge, you can’t reuse it, even if it
contains ink.
❏ Never turn off the printer when the
P
power light is
flashing, unless the printer hasn’t moved or made any
noise for more than five minutes.
Keep ink cartridges out of the reach of children.
If ink gets on your hands, wash them thoroughly with
soap and water. If ink gets in your eyes, flush them
immediately with water.
1. Lower the output tray and open the printer cover.
2. Press the
P power button to turn on the printer. The
P power light flashes and the
B black and
A color ink out
lights come on. The ink cartridge holders move left into
loading position.
Don’t use an outlet that is controlled by a wall switch or
timer, or one on the same circuit as a large appliance, to
avoid damaging the printer’s power supply.
Always use the
P
power button to turn the printer on or
off. Never use an external switch, such as a power strip
switch.
3. Lift up the two ink cartridge clamps.
4. Unwrap the ink cartridges, then remove only the yellow
part of the tape seal on the top. Don’t pull off the blue part.
5. Insert both ink cartridges with the labels facing up as
shown. Press down the clamps until they lock into place,
but don’t press down on the ink cartridges.
6. Press the
R cleaning button and close the printer cover.
Ink charging takes about two minutes, with the
P power
light flashing and the printer making noise until it’s finished.
Don’t turn off the printer or interrupt charging or it will start
over, using more ink than necessary. It’s finished when the
P power light stops flashing.
Testing the Printer
You can run a printer check to determine whether a problem
comes from the printer itself or some other source. Follow
these steps to run the printer check:
1. Make sure both the printer and computer are turned off.
2. Disconnect the interface cable from the printer.
3. Make sure paper is loaded in the printer.
4. Hold down the
E load/eject button, then press and release
the
Ppower button. Continue holding down the
E load/eject button until the
Ppower light starts to flash,
then release it.
black cartridge color cartridge
(376 Seiten)
(96 Seiten)
(179 Seiten)
(172 Seiten)
(24 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern