Epson ML 3320/3321 Betriebsanleitung PDF herunterladen (Seite 17)

Switching Paper Paths

To switch from continuous-forms to single-sheet feed:

1. Tear off any printed pages.

2. Press PARK.

3. Move the paper separator to the single-sheet feed position.

4. Place the wire feed guide in the paper separator.

5. Move the paper lever to the position marked "TOP."

6. Place a sheet of paper in the paper separator.

To switch from single-sheet feed to continuous forms:

1. Press FF/LOAD to remove the single-sheet paper.

2. Lower the paper separator into the continuous-forms

position and swing the wire feed guide over onto the

pull-up roller.

3. Move the paper lever to the position marked "REAR" or

"ВОТ," as appropriate.

4. Load continuous-form paper, then press FF/LOAD.

Read Me First

Setting the Printhead Gap ;§

>—^

The printhead gap is the distance between the printhead and hq

the platen. To adjust the gap, open the access cover and move

the blue lever (O) to the recommended setting from the table

below.

Note: It is recommended that the printer be switched off

prior to removing the access cover.

Media Setting

Media

Setting

45-75g/m

paper 1

2-part form (w/carbon)

3-4

75-90g/m

bond paper 2

3-part form (w/carbon)

4-5

Labels 3-4

4-part form (w/carbon)

Envelopes

iii

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Keine Kommentare

Epson ML 3320/3321 Betriebsanleitung Seite 17