Epson Endeavor Betriebsanweisung PDF herunterladen (Seite 108)

Note

You may find it easier to plug in the cable connector if

you first remove the option card connector board and

diskette drive ribbon cable. To remove the option card

connector board, see page 2-21. To disconnect the

diskette drive ribbon cable, grasp the cable connector

and pull it straight out from the system board connector

so you do not bend the pins; do not pull on the cable.

Make sure the holes in the cable connector fit over all the

pins in the system board connector; then push in the cable

connector.

Caution

If you do not correctly align the holes with the pins, you

could severely damage your system board when you

push in the cable connector.

If you removed the option card connector board and diskette

drive ribbon cable, replace them now. To connect the

diskette drive ribbon cable, align the tab on the cable

connector with the notch in the system board connector.

Make sure the holes in the cable connector fit over all the

pins in the system board connector and push in the cable

connector. Then replace the option card connector board as

described on page 2-22.

Installing and Removing Drives

3-35

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 196 197

Keine Kommentare

Epson Endeavor Betriebsanweisung Seite 108