Epson C82324* Betriebsanweisung PDF herunterladen (Seite 20)

Use EPSETUP for your initial Ethernet Card setup. After setting

the Ethernet Card up on at least one file server, you can use either

EPSETUP or PCONSOLE, to configure the Ethernet Card to

service queues on other file servers. If you

have questions

while using EPSETUP, press F1 for on-line help.

Before setting up

Read Terms and Concepts in the Introduction.

Decide whether you want to use the Ethernet Card as a print

server or as a remote printer. If you need more information, see

the Introduction.

Install the Ethernet Card and connect it to the network, following

the instructions earlier in this chapter. The Ethernet Card must

be connected to the network and the host printer must be

turned

on before setting up.

At a workstation with a high-density floppy drive, use the DOS

COPY command (copy a:*.*) to copy utilities from the Ethernet

Card diskette to a network directory or to your hard drive.

Installing the Ethernet Card as a Print Server

This section describes installing the Ethernet Card as a print

server using EPSETUP. You can configure a number of

parameters using EPSETUP, either during or after installation.

For detailed instructions on configuring specific items with

EPSETUP, see Chapter 2.

Follow these steps to install the Ethernet Card as a print server.

Make sure that the Ethernet Cards host printer is turned on

and that the interface is connected to the network.

Installing the Ethernet Card

1-5

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 56 57

Keine Kommentare

Epson C82324* Betriebsanweisung Seite 20