Epson ES-300C Betriebsanweisung PDF herunterladen (Seite 55)

You may have selected the wrong port number or SCSI ID

during setup. Check the settings for your scanner and any

other SCSI devices you may have. Then reinstall the EPSON

Scanning Utilities.

You may have changed the interface from parallel to SCSI or

from SCSI to parallel without reinstalling the EPSON Scanning

Utilities. Reinstall the Utilities for the correct interface.

You may have tried to install the EPSON Scanning Utilities

using the EZ-SCSI Setup software when you were using an

interface card that does not support EZ-SCSI. The EPSON

Scanning Utilities supports only SCSI host adapter interface

cards which support EZ-SCSI, or are Adaptec compatible.

An error condition may have caused your application or the

TWAIN data source in the EPSON Scanning Utilities to stop

working correctly. Save any documents in process, close any

open applications, and exit Windows. Restart Windows to

restore the TWAIN data source, then start your application and

try again.

Sometimes an error condition may cause the computer to

display a message telling you that your scanner is not

recognized. If this happens, reset your scanner by turning it off

and on or pushing the Reset button. Then restart your

computer and try again.

If you are using Windows 95, its hardware detection utility

may not have correctly detected the SCSI controller. Restart

Windows 95 and see the Windows 95 online Help utility for

instructions on detecting new hardware.

The system fails or an error message appears when you choose

Acquire from your application software.

You may have more than one TWAIN screen open at once.

Reset your computer and use only one active TWAIN screen.

6-2 Troubleshooting

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 85 86

Keine Kommentare

Epson ES-300C Betriebsanweisung Seite 55