Epson 810 Bedienungsanleitung PDF herunterladen (Seite 56)

56 Problem Solving

Solving Picture Problems

You cannot turn on the projector.

■ Make sure the power cord is connected and the power switch is turned on. Then wait a

moment for the power light to turn orange before pressing the P

Power button.

■ If you’ve set the Operation Lock, the control panel buttons are disabled; you must use

the remote control to turn on the projector (see page 31).

No picture appears on the screen or you see the

No Signal message displayed.

■ Press the Source button on the projector or one of the Source buttons on the remote

control to select the correct input source. Allow a few seconds for the projector to sync up

after pressing the button.

■ Press the Blank button on the remote control to make sure the picture hasn’t been turned

off temporarily.

■ Check that the P power light is green, not flashing, and the lens cover is off.

■ The projector may be in standby (or sleep) mode. If the P power light is orange, press the

Power button to turn the projector back on.

■ Make sure your video equipment is turned on.

■ Make sure your cable(s) are connected correctly (see page 18).

Warning light is red The projector is too hot, which turns off the lamp automatically.

Let it cool for five minutes, then turn it back on. Make sure there

is plenty of space around and under the projector for ventilation.

Also, clean or replace the filter if necessary (see page 48).

If you are using the projector at an altitude above 4900 feet (1500

meters), turn on High Altitude Mode so the fan can properly cool

the projector at the high altitude air pressure (see page 46).

Warning light is

flashing red at half-second

intervals

The lamp needs to be replaced (see page 50). Make sure you

have a spare lamp handy. Check to make sure the lamp and lamp

cover are securely installed.

Warning light is

flashing red at one-second

intervals

There is an internal problem.

Turn off the power switch on the

back of the projector, and unplug it from the electrical outlet.

Then contact Epson for assistance (see page 60).

Light state Cause and solution

PowerLite Cinema Pro 810.book Page 56 Thursday, December 6, 2007 11:25 AM

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 75 76

Keine Kommentare

Epson 810 Bedienungsanleitung Seite 56