EPSON®LX-90TM PRINTERUser’s Manual
With the paper feed knob in place, you’re now ready to load paperinto your printer. If you plan to use continuous paper, read the nexttwo sections. Fo
Make sure that the printer is turned off; then open the front lid.Move the print head to the center of the printer, and pull the paper bailaway from t
Open the pin feed covers as shown on the previous page and feedthe paper under the paper separator and into the paper slot. Push thepaper through unti
If you are using a word processing or other applications programand your printing is too high or too low on the page, change your topof page setting.O
Loading Single-Sheet Paper1. First, make sure that the printer is turned OFF. Open the front lid,push the friction lever back, and pull the paper bail
Replacing the Tractor UnitReplacing the tractor after you have removed it is easy.Pull the friction lever on the left side of the printer toward you,
MaintenanceTo keep your LX-90 working like new, always keep it in a safe andclean place. Keep it away from dust, grease, and any heat sources. Asafe t
SpecificationsPrinting method...Impact dot matrixPrinting speed...100 characters per second per line inpica draft modePrinting directi
EPSON AMERICA, INC.LIMITED WARRANTYEpson America, Inc. hereby warrants that it will repair or replace, at its option, anypart of the Epson product wit
FCC COMPLIANCE STATEMENTFOR AMERICAN USERSThis equipment generates and uses radio frequency energy and if not installed and usedproperly, that is, in
ContentsSetting Up Your LX-90 Printer...1Do You Have All the Parts You Need?...1Where to Place Your Printer...
Setting Up Your LX-90™ PrinterSetting up your LX-90 printer is easy, even if you’ve never used aprinter before. By following the instructions in this
Where to Place Your PrinterNow that your printer is unpacked, you need to find the best placeto put it. Keep the following tips in mind:l Place the pr
Many types of printer stands are available; the previous illustrationshows one type. The next illustration shows a setup that does notrequire a stand.
To install or replace the ribbon, just follow these steps:CautionIf you’ve been using your printer just before you change rib-bon cassettes, be carefu
5.Snap the cassette into place so that the exposed ribbon fits betweenthe print head and the silver ribbon guide.6. Now turn the knob on the cassette
Hold the cartridge with the grooved side facing down. Insert thecartridge into the opening and press gently to secure the connection.Do not connect th
Kommentare zu diesen Handbüchern