Epson DS-860 Betriebsanweisung PDF herunterladen (Seite 94)

• Use only the type of power source indicated on the AC adapter's label, and always supply power

directly from a standard domestic electrical outlet with the AC adapter that meets the relevant local

safety standards.

• When connecting this product to a computer or other device with a cable, ensure the correct

orientation of the connectors. Each connector has only one correct orientation. Inserting a connector

in the wrong orientation may damage both devices connected by the cable.

• Avoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on

and off.

• If you use an extension cord with the scanner, make sure the total ampere rating of the devices

plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure the total

ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's ampere

rating.

• Never disassemble, modify, or attempt to repair the AC adapter, scanner, or scanner option by

yourself except as specifically explained in the scanner's guides.

• Do not insert objects into any opening as they may touch dangerous voltage points or short out parts.

Beware of electrical shock hazards.

• If damage occurs to the plug, replace the cord set or consult a qualified electrician. If there are fuses in

the plug, make sure you replace them with fuses of the correct size and rating.

• Unplug the scanner and the AC adapter, and refer servicing to qualified service personnel under the

following conditions: The AC adapter or plug is damaged; liquid has entered the scanner or the AC

adapter; the scanner or the AC adapter has been dropped or the case has been damaged; the

scanner or the AC adapter does not operate normally or exhibits a distinct change in performance. (Do

not adjust controls that are not covered by the operating instructions.)

• Unplug the scanner and the AC adapter before cleaning. Clean with a damp cloth only. Do not use

liquid or aerosol cleaners.

• If you are not going to use the scanner for a long period, be sure to unplug the AC adapter from the

electrical outlet.

• Place the product on a flat, stable surface that extends beyond the base of the product in all directions.

If you place the product by the wall, leave at least 3.9 inches (10 cm) between the back of the product

and the wall. The product will not operate properly if it is tilted at an angle.

• After replacing consumable parts, dispose of them correctly following the rules of your local authority.

Do not disassemble them.

Parent topic: Notices

1 2 ... 89 90 91 92 93 94 95 96 97 98

Keine Kommentare

Epson DS-860 Betriebsanweisung Seite 94