Epson AcuLaser CX11N Betriebsanweisung PDF herunterladen

4105490 Rev.0

1-F C

4105490 Rev.0

1-F M

4105490 Rev.0

1-F Y

4105490 Rev.0

1-F K

Start Here

Cover A

4 With Lang = XXXX selected, press the button.

5 Use the or button to select the desired language, then press

the

button.

Load Paper/Verify Settings

1 Paper Out appears in the LCD screen. Open the MP Tray and place a

stack of up to 80 sheets of paper in the tray. Adjust the paper guide on

the right so that it is snug against the stack. Then close the cover.

2 Press the

Setup button.

The Setup light turns on and the

LCD screen shows Setup Mode

for a few seconds, then changes

to the Setup menu screen.

3 While Printer Settings is

highlighted, press the button.

4 While Information Menu is

highlighted, press the button.

5 While Status Sheet is highlighted, press the button.

A Status Sheet is printed.

6 If you have the CX11NF, place the Status Sheet face up on the Auto

Document Feeder.

If you have the CX11N, place the Status Sheet face down on the

document table.

7 Press the

Copy button on the control panel to enter the Copy mode.

8 Press the

B&W Start button.

The Status Sheet is copied.

Install Software

CX11N as a Local Printer

See “CX11N as a Network Printer” for information on setting up the CX11N as

a network printer.

Windows

1 Make sure the CX11N is not

connected to your computer.

Note: If you see a screen like this,

click Cancel and disconnect the

USB cable. You cannot install your

software that way.

2 Insert the Epson CD-ROM into the

CD drive of your computer.

3 Make sure you close all other

applications. When you see the

following screen, click Continue.

4 Read the license agreement that

appears and click Agree.

5 For the type of installation,

select Local.

Turn over

Epson AcuLaser

CX11N/CX11NF

Unpack

Note: The illustrations show the CX11NF, but the instructions apply to both the

CX11N and CX11NF unless otherwise noted.

1 Check that you have the following:

• 4 toner cartridges (Cyan, Magenta, Yellow, Black)

• Photoconductor unit

• USB cable

• Power cord

• Documentation: Basics Guide, Fax Guide (CX11NF only)

• 3 software CD-ROMs

2 Select a location for the CX11N. Make sure you allow enough space

around the product to ensure smooth operation.

a 36.2 in. (920 mm)

b 10.2 in. (258 mm)

c 34.2 in. (868 mm)

d 3.9 in. (100 mm)

e 11.8 in. (300 mm)

The optional 500-Sheet Paper Cassette Unit adds

5.1 in. (130 mm) to the bottom of the CX11N.

3 Remove all the packing tape from the outside of

the unit.

4 Raise the scanner unit, then open cover C

and pull out the insert.

5 Close cover C and lower the scanner unit.

6 Open cover A and remove the foam

insert. Then close the cover.

7 Open the document cover and remove

the insert. Then unlock the carriage lock.

8 Close the document cover.

Cover C

9 Connect the power cord to the

CX11N and to an AC outlet.

10 Push the power switch to On.

Install Toner Cartridges

Caution: Make sure the CX11N is turned on before installing the toner

cartridges. Do not install the photoconductor before installing the toner

cartridges.

1 Open cover A and remove the

tape and plastic insert.

2 In the LCD screen the message

Install [X] Toner Cartridge

appears, where [X] is one of

the following:

•

Y: Yellow

•

M: Magenta

•

C: Cyan

•

K: Black

3 Remove the toner cartridge from its

package and gently shake it.

Warning: Do not touch the toner. Keep

the toner away from your eyes. If toner

gets on your skin or clothes, wash it off

with soap and water immediately.

4 Hold the tag and gently pull the toner seal

until it comes completely out.

5 Slide the toner cartridge into the tracks inside the printer. Push evenly on

both sides until the cartridge stops securely in its slot.

If the cartridge doesn’t

seem to be installed fully,

remove it and reinstall it.

Caution: Don’t force the

cartridge into the printer

or force the lock lever

down, or you may damage

the printer.

6 Push down the lever to

lock the toner cartridge.

Note: The toner cartridge

is installed securely when

you cannot turn the lock

lever any further.

7 Close cover A and confirm the message in the LCD screen.

The LCD screen will display the next cartridge that needs to be

installed. Open cover A and repeat steps 3 to 7 for each of the

remaining toner cartridges.

Install Photoconductor

Caution: Make sure the CX11N is turned on and you have installed all the toner

cartridges, as described in the previous section.

1 Install Photoconductor appears in the LCD screen. Lift up the scanner.

2 Lift up cover B and raise the orange lever

inside, on the right.

3 Remove the photoconductor from its package

and pull off the protective sheet.

Caution: Do not touch the belt on the top

of the photoconductor or the blue roller beneath

it; otherwise, print quality may decrease.

Avoid exposing the photoconductor to light any longer than necessary.

Do not touch any other components inside the CX11N.

4 Hold the photoconductor by

its handle and insert it into the

slots marked with blue arrows

inside the CX11N. Push it in

until it clicks into place.

5 Flip down the orange lever,

then close cover B.

6 Pull out the extension tray if necessary. Lower the scanner unit to its

original position.

Set Fax/Printer Information

CX11NF

1 Select the Country: Press the or button to select the country,

then press the button.

2 Select the Language: Press the or button to select the language,

then press the

button.

3 Set the Date and Time: Press the or button to select the year,

month, day, hour, and minute. Press the button after selecting each

item. The CX11NF then resets itself and reboots.

4 Turn off the CX11NF.

5 Connect an RJ-11 cord to

the telephone line interface

on the CX11NF and to the

RJ-11 jack on the wall.

Note: An RJ-11 cord is not

included with the CX11NF.

6 Turn on the CX11NF.

CX11N

1 Press the

Setup

button.

The Setup light turns on and the LCD screen shows Setup Mode for a

few seconds, then changes to the Setup menu screen.

2 Press the ▼ button until Printer Settings is selected, then press the

▲

button.

3 Press the ▼ button until Setup Menu is selected, then press the

▲

button.

1 2 3 4 5 6 7 8

Start Here 1
Questions? 5

Inhaltsverzeichnis

Seite 1 - Start Here

4105490 Rev.01-F C4105490 Rev.01-F M4105490 Rev.01-F Y4105490 Rev.01-F KStart HereCover A 4 With Lang = XXXX selected, press the button.5

Seite 2

4105490 Rev.01-F C4105490 Rev.01-F M4105490 Rev.01-F Y4105490 Rev.01-F KStart HereCover A 4 With Lang = XXXX selected, press the button.5

Seite 3

4105490 Rev.01-F C4105490 Rev.01-F M4105490 Rev.01-F Y4105490 Rev.01-F KStart HereCover A 4 With Lang = XXXX selected, press the button.5

Seite 4

4105490 Rev.01-F C4105490 Rev.01-F M4105490 Rev.01-F Y4105490 Rev.01-F KStart HereCover A 4 With Lang = XXXX selected, press the button.5

Seite 5 - Questions?

4105490 Rev.01-B C4105490 Rev.01-B M4105490 Rev.01-B Y4105490 Rev.01-B K 11 In OS X 10.4.x, select AL-CX11. In OS X 10.2.x to 10.3.x, se

Seite 6

4105490 Rev.01-B C4105490 Rev.01-B M4105490 Rev.01-B Y4105490 Rev.01-B K 11 In OS X 10.4.x, select AL-CX11. In OS X 10.2.x to 10.3.x, se

Seite 7

4105490 Rev.01-B C4105490 Rev.01-B M4105490 Rev.01-B Y4105490 Rev.01-B K 11 In OS X 10.4.x, select AL-CX11. In OS X 10.2.x to 10.3.x, se

Seite 8

4105490 Rev.01-B C4105490 Rev.01-B M4105490 Rev.01-B Y4105490 Rev.01-B K 11 In OS X 10.4.x, select AL-CX11. In OS X 10.2.x to 10.3.x, se

Kommentare zu diesen Handbüchern

Keine Kommentare

Epson AcuLaser CX11N Betriebsanweisung

Stöbern Sie online oder laden Sie Betriebsanweisung nach Drucken & Scannen Epson AcuLaser CX11N herunter. Epson AcuLaser CX11N User`s guide Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Drucken & Scannen Epson AcuLaser CX11N